Dale Hold-n-Place Foley Catheter Holder

A. Clean the application area and prepare for patch application.

B. Open Dale Hold-n-Place catheter holder to expose center liners. Remove the center liners and place the urinary catheter onto the exposed adhesive.

C. Wrap the locking tab beyond the lumen of the catheter, where the drainage bag connects. The user may remove the top liner for extra security. Remove baseliners to expose adhesive and apply to skin.

D. Dale Hold-n-Place should appear as shown when securement is complete.

1. Position leg band high around the thigh with Dale's product label pointing to the inside of leg. Stretch leg band in place and fasten velcro tab. Proper compression is achieved when two fingers fit snugly under the band.

2. Place foley catheter over white stitching of green tab. Leave an ample loop in catheter above leg band to avoid bladder traction; or stretch the catheter for traction when required.

3. With catheter in desired position, insert the narrow, green tab over catheter and through the square opening so that the green tabs overlap.

4. Lock catheter in position by pulling green tabs in opposite directions. Secure tabs in place. To re-position catheter: raise either green tab, adjust catheter and refasten tab.

5. Another method of securement is to locate the Y port of the proximal end of the catheter into the locking device.