Bard StatLock Pediatric Foley Stabilization Device

What to buy with Bard StatLock Foley Stabilization Device

• Bard Urine Drainage Bag With Anti-Reflux Chamber
• Bard Urine Meter Foley Catheter Tray
• Bard Catheter Plug And Cap

How to use Foley Catheter Stabilization Device?

• Preparation:
  
  • Place Foley catheter into the retainer. The directional arrow should point towards catheter tip, and the balloon inflation arm should be next to the clamp hinge
  • Close lid by placing your fingers under the pad and pressing the grip markers at the end of the clamp with your thumb, being careful to avoid pinching the catheter
  • Identify proper securement site by gently laying the StatLock Foley catheter securement device straight on the front of the thigh, then back up one inch towards the insertion site. Make sure leg is fully extended. Gently place the StatLock pediatric Foley stabilization device off to the side, away from the selected securement site.
  • Cleanse and de-grease securement site with alcohol. Let skin dry. Be sure to clean area larger than securement site.
  • Apply skin protectant in direction of hair growth, to an area larger than securement site. Allow drying completely (10-15 seconds)
  • Using a permanent marker, write initials and date of application on StatLock anchor pad
  
  NOTE: Always secure catheter into the StatLock stabilization device retainer before applying adhesive pad on the skin


• Place and Peel:
  
  • Align the device over securement site, leaving one inch of catheter slack between insertion site and the device retainer. Make sure leg is fully extended
  • While holding the retainer to keep the pad in place, peel away paper backing, one side at a time, and place tension-free on the skin

• Disengage:
  
  • Open retainer by pressing release button with thumb, then gently lift to open
  • Remove Foley catheter
• Dissolve:
  
  • Wipe the edge of the pad using at least 5-6 alcohol pads until a corner lifts. Then continue to stroke undersurface of the pad, in a back-and-forth motion, by squeezing the alcohol out to dissolve the adhesive pad away from the skin.
  • Do not pull or force pad to remove

How to Care for StatLock Foley Stabilization Device?

• StatLock pediatric Foley stabilization device should be assessed daily and changed at least every seven days
• If the pad becomes soiled, then wash with soap/water, saline or hydrogen peroxide
• Do not use alcohol or prepackaged bathing systems, which could lead to early lifting
• If showering/bathing, then cover with plastic wrap or waterproof dressing
• Evaluate skin integrity prior to application
• Consult your healthcare professional about the removal of the Foley catheter StatLock stabilization device if you experience any shifts in the fluid input that may interfere with skin integrity

• Known tape or adhesive allergies

• Do not use the Statlock Foley stabilization device where loss of adherence could occur, such as with a confused patient, unattended access device, diaphoretic or non-adherent skin, or when the access device is not monitored daily.
• Observe universal blood and body fluid precautions and infection control procedures, during the Statlock device application and removal
• Catheter insertion site should be treated per established hospital policy and procedure
• Minimize catheter manipulation during device application and removal
• The Statlock device pad adherence and catheter/tube position should be routinely inspected

Customer Reviews