Encore Deluxe Battery And Manual Vacuum Erection Device

Frequently Bought Together

Personal Lubricated Jelly

Oversized Tube For Pump

Replacement Penis Ring

How to use Encore Vacuum Therapy System?

Step 1. Put the Encore Penis Pump in one end of the tube and the ring ejector on the other.

1. The system will not work unless the user have a good vacuum seal. The user will need two types of lubricants to use system. The first is a water soluble lubricant such as K-Y Jelly. Second, use a petroleum based lubricant, such as Vaseline, on the 0-Ring that seals the pump and tube.
2. To put the system together, twist the pump into the penile tube.
3. The ring ejector will slip over the smaller side of the penile tube (opposite the pump). Push the pointed end of the ejector toward the pump until it stops. Lubricate the tube with water soluble lubricant.

Step 2. Choosing the best tension ring.

One of the most important parts of the vacuum system is the Ring. It is important to have a properly fitted Ring to retain blood in the penis to maintain a good erection. The ring must encircle the penis and fit comfortably tight, but should be no tighter than necessary.

1. Start by choosing the size the user thinks will fit best. Try that size while learning how to use the system.
2. We recommend starting with the larger sizes to assure that the compression on the penis is no more than necessary to accomplish results. If the vacuum unit gives a good erection, and with the Ring on, erection becomes soft within five minutes or less, the user need to try the next size smaller Ring. If the ring seems tight, choose the next size larger.
3. Try the different sizes until satisfied with the fit. The user have many rings to choose from.
4. If the user is one of the rare cases where the smallest ring will not keep penis firm, the user may use two rings. Example: (sizes 4 & 5). Mount the second ring by repeating step 2.

Step 3. How to mount the tension ring on Encore Vacuum Pump?

1. Insert the mounting cone into the end of the penile tube that has the ring ejector.
2. Lubricate the cone and the center of the ring with water soluble lubricant.
3. Get in a comfortable sitting position. Place the open end of the tube between the thighs and squeeze firmly with the thighs to steady the tube. Grab the handles of the ring; pull the ring quickly down the cone onto the tube.
4. Before using the pump, lubricate the end of the penile tube with water soluble lubricant to seal the vacuum pull (where the penile tube meets the base of the penis). Also, lightly lubricate the penis to prevent it from sticking to the inside of the penile tube during insertion and vacuum.

Step 4. Scrotal tissue protection with barrier shield.

1. A small amount of men, 5%, may pull scrotal tissue into the tube while creating a vacuum. If this occurs, a body shield can be used to prevent this problem.
2. Place the body shield over the penis until it is snug and covering the pubic bone area and pubic hair.
3. Place water soluble lubricant on both the body and shield and tube to help get a good seal.
4. Place penis in tube and follow instructions. Once placed the Ring on the penis, the user may remove the body shield by stretching it over the ring.

Step 5. How to draw vacuum to a desired erection?

1. Insert the penis into the penile tube and apply slight pressure against the body at the base of the penis to assure a vacuum. Simply depress the vacuum plunger to engorge the penis with blood.
2. It is recommended that the easiest and best way to draw a vacuum, with the vacuum pump, is to place both thumbs behind the thumb grip and with the fingers of both hands, squeeze the pump's plunger towards the user. This also will prevent any jerking motions that can possibly cause the body to bruise where the penile tube is held tight against the groin. We have found this way requires the least amount of effort.
3. Battery Powered Penis Pump - Insert the penis into the penile tube and apply slight pressure against the body at the base of the penis to assure a vacuum. Simply push the switch to the on position to engorge the penis with blood. When the penis is fully engorged, push the switch off.

Step 6. Put the tension ring on the penis.

1. As soon as the desired erection has been achieved, continue to hold the tube tight against body and simply twist the ring ejector just like turn a door knob. This will automatically push the Ring off the penile tube onto and around the base of the penis.
2. Twist ring ejector. Most of the vacuum seal will be broken during the ring's transfer, but the user may still need to depress the release valve to release what vacuum may be left. Remove the pump unit from the penis.
3. A lasting erection should now be maintained, and normal intercourse can be accomplished. Note: If a condom is desired, it should be put on as the last step. Do not wear a condom during the vacuum process. If the user use a condom, put it on after the constriction ring is in place.
4. After intercourse, remove the ring(s) by pulling the top and bottom handles. The ring(s) will stretch and erection will go down. Pull the ring(s) off the penis.

Warnings

• In some rare cases, frequent use of rings may bruise the base of the penis. The base of the penis is where the shaft of the penis meets the pubic area.
• Stop drawing a vacuum if severe pain occurs. Pain may be a sign the penis is being bruised.
• Theoretically, it is possible that using the pump may bruise or break the blood vessels either right below the skin or deep within the penis or scrotum. Internal bleeding or a blood filled bruise in the penis can result.
• The vacuum pump may not be safe for men who do not feel pain in the area around their penis. If the user has diabetes, the user may have a reduced ability to feel pain. Pain may be a sign the penis is being bruised.
• Do not use if under the influence of drugs or alcohol. The user may not feel pain while using drugs or alcohol.
• The user must wait 60 minutes between uses. Failure to do so may injure penis.
• Use the largest ring that will keep penis hard. Using a ring that is too small may bruise penis.
• If hands are severely impaired, the user should not use this product. The user must have full use of hands to safely use the rings and pump. If the user does not have enough strength in hands, the user may not be able to remove the ring. Delayed ring removal could damage penis.

Compare Your Encore Penis Pumps

Frequently Asked Questions

1. How long do you wear the Tension Ring?

The Tension Ring should be worn for no more than 30 minutes. After the ring is removed, please wait 1 hour before creating another erection.

2. What if I am not able to achieve a full erection the first time I use the system?

Practice sessions may be necessary to achieve a satisfactory erection if it has been awhile since you have good potency. A practice session is when you take 5 minutes a day (for 1 to 2 weeks) and create as many erections as you can in this time period. You simply create an erection and hold it for around 5-10 seconds. You then release the pressure by pressing the "pressure release button" and you will lose the seal and the erection. After that you, you simply repeat the same procedure again and again until you have done so for 5 minutes. This will free up proper blood flow and help restore the corpora cavernosa (the two canals that fill with blood). This is a safe and effective way to rehabilitate.

3. Is there an age limit to using Vacuum Therapy?

No, there is no age limit as Vacuum Therapy works regardless of your age.

4. Will the Encore System work if I have had Prostate Cancer Surgery?

Vacuum Therapy is often used by Urologists as a proven therapy to restore potency following Radical Prostatectomy Surgery.
 

Customer Reviews